What to do if my Daikin R35FV1M Air Conditioner unit does not operate?
If your Daikin Air Conditioner unit is not operating, first check the power supply, ensuring there is no power failure or blown fuse. Next, verify that the power plug is securely connected. Also, check the delay timer settings to ensure they are correct. If the problem continues after these checks, it is recommended to contact the air conditioner unit installer.
How to increase air flow in my Daikin R35FV1M Air Conditioner?
If the airflow from your Daikin Air Conditioner is too low, start by cleaning or replacing the air filter. Ensure all doors and windows are closed to prevent drafts. Check for and clear any clogs in the air suction and discharge. Finally, adjust the regulated temperature to a higher setting.
How to get rid of bad odor from Daikin R35FV1M?
If your Daikin Air Conditioner has a bad odor, it may be caused by particles like cigarettes, smoke, or perfume adhered to the coil. Clean the coil to remove these odors.
Why is there condensation on my Daikin R35FV1M?
Condensation on the front air grille of your Daikin Air Conditioner indoor unit is typically due to air humidity after prolonged operation. To resolve this, increase the temperature setting and operate the unit at a high fan speed.
What is the reason for hissing sound from Daikin R35FV1M Air Conditioner?
It is normal to hear a hissing sound from your Daikin Air Conditioner during operation, which is caused by refrigerant fluid flowing into the evaporator coil.
General| Brand | Daikin |
|---|---|
| Model | R35FV1M |
| Category | Air Conditioner |
| Language | English |
Provides dimensions for FT20FV1M/FT25FV1M and FT28FV1M/FT35FV1M models.
Lists dimensions for R20FV1M/R25FV1M and R35FV1M outdoor units.
Lists dimensions for R50FV1M and R60FV1M9 outdoor units.
Lists the available indoor and outdoor unit models.
Lists critical safety warnings for installation and maintenance.
Specifies minimum installation clearances for the outdoor unit.
Explains how to route refrigerant piping for the indoor unit.
Describes how to mount the indoor unit onto its installation plate.
Details correct installation of the indoor unit's drain pipe.
Covers the process of mounting the indoor unit's installation plate.
Provides guidelines on pipe length, elevation, and bends for refrigerant lines.
Details procedures for cutting, flaring, and connecting copper pipes.
Specifies torque values for tightening flare nuts on refrigerant pipes.
Wiring diagram for indoor-powered cooling units.
Wiring diagram for outdoor-powered cooling units.
Steps for purging air and moisture from the refrigerant system.
Guidelines for adding refrigerant based on piping length.
Procedure for charging refrigerant into the unit.
Explains the IR receiver and beep confirmation.
Overview of LED indicators for normal and fault conditions.
Details specific LED patterns and their meanings.
Explains the operation and conditions for Dry Mode.
Describes how to adjust airflow direction.
Explains frost formation and defrosting mechanisms.
Information on fan speeds and cooling capacity.
Lists standard operating temperature ranges for cooling.
Explains the auto re-start function after power interruption.
Safety warnings related to servicing the unit.
Instructions for cleaning the indoor air filter.
Instructions for cleaning the indoor unit's grille and panel.
Details the steps to clean the unit's blower fan.
Warning about placing heating devices near the unit.
Procedure for preparing the unit for long-term storage.
Addresses compressor start-up and unit non-operation issues.
Covers low airflow and bad discharge air odour.
Addresses condensation on grille and water leakage.
Explains causes of hissing sounds during operation.
To Next Page