M4 x 12 Screw
Front Panel
Intake grille
Grille stopper
All dimensions are in mm
Indoor Unit Installation
Fixing Procedure
• Fix the indoor unit by using embedded bolt, etc. to prevent falling down of the vertically-long shaped
unit.
1. Detach the air intake grille.
Remove the screw (Right, Left, total 2) holding the grille. Then, (1) lean the grille forward you, and (2)
lift upward and out. Refer Figure C.
2. Install the indoor units.
< Method 1 >
Fix the bracket with the attached screws to the top panel as shown in Figure D.Then fix the indoor
unit to the wall surface.2.
To Next Page
Loading...
