Need help?Do you have a question about the Daikin RK18NMVJU and is the answer not in the manual?
General| Brand | Daikin |
|---|---|
| Model | RK18NMVJU |
| Category | Air Conditioner |
| Language | English |
Detach and remove the top panel, front panel, and discharge grille from the outdoor unit.
Disconnect fan motor wiring, covers, and clamps for safe removal.
Remove the outdoor fan, its fixing frame, and the fan motor assembly.
Remove terminal board, conduits, and disconnect various internal electrical connectors.
Disconnect remaining connectors and remove the main electrical box unit.
Remove terminal board screws, earth/ground screws, and clamps.
Remove earth/ground screws, clamps, and release the relay harness.
Unfasten hooks and remove screws to detach the main PCB unit.
Remove the stop valve cover and the main right side panel.
Remove outdoor heat exchanger and discharge pipe thermistors, then the partition plate.
Remove the back, top, and outer sound blankets carefully.
Remove the inner sound blanket, following specific reassembly order.
Pull out and remove the electronic expansion valve coil.
Remove the four way valve coil, terminal cover, protection bushing, and disconnect compressor leads.
Heat and remove the electronic expansion valve and the four way valve.
Remove terminal cover, protection bushing, and disconnect compressor lead wires.
Heat and disconnect pipes, remove nuts, and lift out the compressor unit.
To Next Page
