Need help?Do you have a question about the Daikin RKS71B2VMB and is the answer not in the manual?
Disconnect motor connector, remove nut and screws to detach fan motor.
Remove side panel, service monitor PCB, and main PCB by disconnecting wires and removing fasteners.
Lift partition plate, remove screw, and slide out the reactor.
Heat the brazed part and disconnect the four way valve.
Remove putty, heat brazed parts, and detach the valve.
Remove terminal cover and disconnect the compressor lead wires.
Disconnect motor connector, remove nut and screws to detach fan motor.
Remove side panel, service monitor PCB, and main PCB by disconnecting wires and removing fasteners.
Lift partition plate, remove screw, and slide out the reactor.
Heat the brazed part and disconnect the four way valve.
Remove putty, heat brazed parts, and detach the valve.
Remove terminal cover and disconnect the compressor lead wires.
General| Cooling Capacity | 7.1 kW |
|---|---|
| Heating Capacity | 8.0 kW |
| Refrigerant | R32 |
| Power Supply | 220-240V, 50Hz |
| Type | Split System |
To Next Page
