Why Daikin Air Conditioner is not turning on? (OPERATION lamp is off)
If your Daikin Air Conditioner isn't turning on and the OPERATION lamp is off, check the following: * Ensure the breaker hasn't been turned OFF or a fuse hasn't blown. * Verify that there isn't a power failure. * Confirm that batteries are correctly installed in the remote controller. * Check if the timer setting is correct.
What to do if Daikin RX25BVMB Air Conditioner operation stops suddenly? (OPERATION lamp is on)
If your Daikin Air Conditioner stops suddenly and the OPERATION lamp is on, it might be due to a sudden large voltage fluctuation. For system protection, the air conditioner automatically resumes operation in about 3 minutes.
Why Daikin RX25BVMB operation does not start soon?
If your Daikin Air Conditioner doesn't start immediately after pressing the ON/OFF button soon after stopping or reselecting the mode, wait for about 3 minutes.
Why Daikin RX25BVMB Air Conditioner outdoor unit emits water or steam?
The outdoor unit of your Daikin Air Conditioner may emit water or steam. This can occur in HEAT mode when frost on the outdoor unit melts during defrost operation. In COOL or DRY mode, moisture in the air can condense on the cool surface of the outdoor unit piping and drip.
Why is my Daikin Air Conditioner cooling effect poor?
If the cooling or heating effect of your Daikin air conditioner is poor, consider the following: * Ensure the air filters are clean. * Check for any obstructions blocking the air inlet or outlet of the indoor and outdoor units. * Verify that the temperature setting is appropriate. * Confirm that all windows and doors are closed. * Make sure the airflow rate and direction are set correctly.
How to improve cooling (heating) effect of Daikin RX25BVMB Air Conditioner?
If you're experiencing poor cooling or heating with your Daikin Air Conditioner, consider these points: * Ensure the air filters are clean. * Make sure nothing is blocking the air inlet or outlet of the indoor and outdoor units. * Verify that the temperature setting is appropriate. * Confirm that windows and doors are closed. * Check if the airflow rate and direction are set correctly. * Check if the unit is set to the INTELLIGENT EYE mode.
Why my Daikin RX25BVMB Air Conditioner smells bad?
If your Daikin Air Conditioner's indoor unit is emitting an odor, it's likely due to smells from the room, furniture, or cigarettes being absorbed into the unit and discharged with the airflow. If this occurs, it is recommended to have the indoor unit cleaned by a technician.
Why Daikin RX25BVMB Air Conditioner hot air does not flow out soon after the start of heating operation?
If hot air doesn't flow out immediately after starting the heating operation on your Daikin Air Conditioner, allow 1 to 4 minutes for the system to warm up. The system is designed to discharge air only after reaching a certain temperature.
Why Daikin RX25BVMB Air Conditioner heating operation stops suddenly and a flowing sound is heard?
If the heating operation on your Daikin Air Conditioner stops suddenly and you hear a flowing sound, the system is likely removing frost from the outdoor unit. Wait for about 3 to 8 minutes.
Why does Daikin RX25BVMB Air Conditioner release mists from the indoor unit?
Mists may come out of the indoor unit of your Daikin Air Conditioner when the air in the room is cooled into mist by the cold airflow during cooling operation.
General overview of the manual and safety precautions.
Details of functions for Cooling Only and Heat Pump models.
Technical specifications for Cooling Only and Heat Pump models.
Wiring diagrams for indoor and outdoor unit PCBs.
Overview of primary operational functions like frequency control and auto-swing.
Details on mode hierarchy, frequency control, and operational logic.
Overview of system setup and initial operation procedures.
Detailed instructions and safety precautions for specific models.
Important cautions and guidelines before starting diagnostic procedures.
Guides for identifying and resolving common errors and malfunctions.
Specific checks for electronic expansion valve, four-way valve, and thermistors.
Step-by-step guide for removing indoor unit components.
Step-by-step guide for removing outdoor unit components.
Additional explanations on trial operation and remote controller settings.
Configuration settings for indoor unit PCB and remote controllers.
Schematic diagrams illustrating refrigerant piping for indoor and outdoor units.
Electrical wiring diagrams for indoor and outdoor units.
General overview of the manual and safety precautions.
Details of functions for Cooling Only and Heat Pump models.
Technical specifications for Cooling Only and Heat Pump models.
Wiring diagrams for indoor and outdoor unit PCBs.
Overview of primary operational functions like frequency control and auto-swing.
Details on mode hierarchy, frequency control, and operational logic.
Overview of system setup and initial operation procedures.
Detailed instructions and safety precautions for specific models.
Important cautions and guidelines before starting diagnostic procedures.
Guides for identifying and resolving common errors and malfunctions.
Specific checks for electronic expansion valve, four-way valve, and thermistors.
Step-by-step guide for removing indoor unit components.
Step-by-step guide for removing outdoor unit components.
Additional explanations on trial operation and remote controller settings.
Configuration settings for indoor unit PCB and remote controllers.
Schematic diagrams illustrating refrigerant piping for indoor and outdoor units.
Electrical wiring diagrams for indoor and outdoor units.
General| Category | Air Conditioner |
|---|---|
| Model | RX25BVMB |
| Type | Split System |
| Cooling Capacity | 2.5 kW |
| Heating Capacity | 3.2 kW |
| Power Supply | 220-240V, 50Hz |
| Refrigerant | R32 |
| Indoor Unit Weight | 8 kg |
| Outdoor Unit Weight | 28 kg |
| Indoor Unit Noise Level | 19 dB |
To Next Page
