To Next PageTo Next PageWhy is my Daikin RXYQ18PY1 Heat Pump system not operating at all?
If your Daikin Heat Pump system isn't operating, consider these potential causes: a power failure (wait until power is restored), a blown fuse (turn off the power supply), or a blown breaker (turn the power on with the ON breaker switch in the off position).
Why is my Daikin Heat Pump system operating but cooling or heating is insufficient?
There could be several reasons why your Daikin Heat Pump isn't cooling or heating sufficiently: * Check if the air inlet or outlet of the outdoor or indoor unit is blocked by obstacles. If so, remove any obstacles to ensure proper ventilation. * Check if the remote control display shows the time to clean the air filter. Clean the air filter if necessary. * Check if there are open doors or windows and shut them to prevent wind from coming in. * Use curtains or blinds if direct sunlight enters the room during cooling operation. * Also check the temperature setting, the fan speed setting, and the air flow angle.
What to do if the display 'TEST', the unit number and the operation lamp flash and the malfunction code appears on Daikin Heat Pump?
If the display shows 'TEST', the unit number and the operation lamp flash, and a malfunction code appears, notify your Daikin dealer and report the malfunction code.
What to do if my Daikin RXYQ18PY1 system stops soon after starting?
If your Daikin Heat Pump system stops shortly after starting, check if the air inlet or outlet of either the outdoor or indoor unit is blocked by any obstacles. Remove any obstructions to ensure proper ventilation. Also, check if the remote control display indicates it's time to clean the air filter and clean the air filter if needed.
General| Model | RXYQ18PY1 |
|---|---|
| Category | Heat Pump |
| Cooling Capacity (kW) | 5.0 |
| Power Source | Electric |
| Cooling Capacity | 5.0 kW |
| Refrigerant | R410A |
| Heating Capacity | 6.0 kW |
Details model names, external appearance, combinations, and selection criteria for outdoor units.
Key considerations for system design, performance, and installation balance.
Step-by-step installation procedures and work details for individual operations.
Covers procedures, power-on sequences, PC board layout, and field settings for testing.
Provides critical safety information regarding refrigerant leaks and concentration.
Outlines the steps and important points for handing over the installed system.
Contains supplementary data on noise, piping, examples, and diagrams for reference.
Covers installation procedures, safety, and troubleshooting for 50Hz models.
Covers installation procedures, safety, and troubleshooting for 60Hz models.
Details safety, specifications, operation, and troubleshooting for 50Hz models.
Details safety, specifications, operation, and troubleshooting for 60Hz models.
Covers R-410A characteristics, cylinders, and necessary service tools.
