Need help?Do you have a question about the Daikin Super Multi NX FVXS35FV1B and is the answer not in the manual?
General| Brand | Daikin |
|---|---|
| Model | Super Multi NX FVXS35FV1B |
| Category | Air Conditioner |
| Language | English |
Details PCB connectors and components for Wall Mounted, Floor Standing, and other indoor unit types.
Provides wiring diagrams and connector details for wired and wireless remote controllers.
Details the PCB connectors and components for the outdoor unit, including main and service monitor PCBs.
Guides on diagnosing issues by interpreting LED indicators on indoor and outdoor units.
Lists common problems and their corresponding solutions or checks, including troubleshooting steps.
Explains how to use the service check function via the remote controller for diagnosis.
Lists error codes and their descriptions for RA and SA indoor units, and outdoor units.
Provides detailed troubleshooting steps for various abnormalities specific to RA indoor units.
Explains how to troubleshoot communication errors between indoor and outdoor units.
Provides troubleshooting steps for SA indoor units including PCB, drain, fan motor, and thermistor issues.
Covers troubleshooting steps for indoor unit PCB abnormalities.
Details troubleshooting steps for outdoor unit issues like anti-icing, PCB abnormalities, and compressor problems.
Provides troubleshooting steps for abnormalities related to the outdoor unit PCB.
Details troubleshooting for compressor overload issues, including checking thermistors and refrigerant.
Guides on troubleshooting compressor lock conditions, including checking power supply and inverter checker.
Outlines various checks for components like thermistors, fan motors, Hall IC, and power supply.
Provides step-by-step instructions for removing outer panels, electrical box, and other components.
Details the steps for removing the fan motor, including fixing plates, nuts, and lead wires.
Provides instructions for removing the main PCB and service monitor PCB.
Details the forced cooling and heating modes, including conditions, start, end, and operating room settings.
Describes the wiring error check function for correcting wiring issues and its limitations.
Outlines the procedures for trial operation of RA and SA indoor units, including checking voltage and settings.
Covers settings related to model type, units in a room, and jumper/switch configurations.
To Next Page