IM 907 / Page 22 of 24
Replacement Parts
All replacement parts and controls are proprietary in that
they have all been designed, tested, and approved for the
particular application to insure both physical and electri-
caltandperformance.Anysubstitutionofpartsorcon-
trols not approved by the factory will be at customer’s
risk.
Note: Daikin reserves the right to substitute parts of
advanced design and to change specications or prices
without advance notice or without incurring obligations.
Replacement parts can be obtained by submitting the
model number, power code, control code and serial num-
ber shown on the rating plate attached to the unit, along
with a description of the part, to the factory.
When writing for service or replacement parts, direct
your letters to Daikin Service and refer to the model
number and the serial number of the heater as stamped
on the serial plate attached to the heater kit. If replace-
ment parts are required, give the date of the heater kit
installation and the date of the failure; also, give descrip-
tion of replacement parts and explanation of malfunction.
Unit heaters used under excessive pressures or tempera-
tures may have failures to the heat exchanger not covered
under our warranty.
Unit heaters used in the presence of corrosive com-
pounds may have failures to the heat exchange not cov-
ered under our warranty.
To Next Page
Loading...
