Place your fingers on the indentation on
the left and right sides of the main unit and
open until the panel stops.
1. Open the front panel.
(Follow the same procedure for closing.)
2. Remove the front panel.
Push the axes on either side of the front panel
towards the center of the main unit and
remove.
(
You can also remove it by sliding the front panel
either to the left or right and pulling it forward.
)
3. Clean the front panel.
• Wipe gently with a soft wet cloth.
• Only use neutral cleaning agents.
• After washing off, wipe off any excess water
and dry in a shaded location.
• When very grimy
Directly apply the type of detergent used for
cleaning ventilation fans or ovens, wait 10
minutes, and then rinse with water
.
NOTE
• Do not wash the air conditioner with hot water of
more than 50°C. Doing so may result in discol-
oration or deformation.
4. Attach the front panel.
Set the keys of the front panel into the slots
and push them in all the way.
Close the front panel slowly in this state.
4
Disposal requirements
Your air conditioning product is
marked with this symbol. This means
that electrical and electronic products
shall not be mixed with unsorted
household waste.
Do not try to dismantle the system yourself: the
dismantling of the air conditioning system,
treatment of the refrigerant, of oil and of other
parts must be done by a qualified installer in
accordance with relevant local and national
legislation.
Air conditioners must be treated at a specialized
treatment facility for re-use, recycling and
recovery. By ensuring this product is disposed of
correctly, you will help to prevent potential
negative consequences for the environment and
human health. Please contact the installer or
local authority for more information.
Batteries must be removed from the remote
controller and disposed of separately in
accordance with relevant local and national
legislation.
To Next Page
Loading...
