Daikin VRV - Page 60

60
Featured Controllers (cont.)
DMS502B71 – Interface for use in BACnet
®
Interface for use in BACnet is a hardware gateway solution
that enables the BMS to monitor and control the VRV indoor
units through BACnet/IP protocol.
To resolve the challenges of integrating the VRV systems,
Daikin provides BMS Plug-ins to the integrators for easy
integration with the VRV system. BMS Plug-ins are pre-programmed
objects and graphics built for Niagara AX
®
specifically for Daikin VRV.
By the use of free-of-cost BMS Plug-ins, the integrators work load could
be reduced to as little as point linking.
DTA116A51 – DIII-Net/Modbus Communication Adaptor
The DIII-Net/Modbus Communication adaptor can be
used for Home automation system integration. With the
adaptor, up to 16 indoor units can be controlled through
Modbus/RTU.
DMS504C71 – Interface for use in LonWorks
®
Interface for use in LonWorks is a hardware gateway solution
that enables the BMS to monitor and control the VRV indoor
units through LonWorks communication.
750-831 - WAGO BACnet/IP Controller
The WAGO BACnet/IP Controller is a programmable
controller that connects the WAGO I/O system to the
BACnet protocol. With the customizable programming
provide by the Daikin Controls team, WAGO
BACnet/IP controller can help fulfill most project
control requirements for Daikin and third-party
equipment control.