Daikin VRVIII-S Series - Wiring Diagram

•VRV
®
Systems • Indoor Units
9
• Indoor Units • 4-WAY BLOW CEILING SUSPENDED CASSETTE • FXUQ-MAV1
8 Wiring diagram
8 - 1 Wiring diagram
3
FXUQ-MA
3D044973A
Note 1
BEV unit
Power Supply
50
~
220-240V
Indoor unit
(Note 3)
Receiver/display unit
Wired remote
control
Control box
Note 5
NOTES
1 The BEV unit shows an outline, please refer to a wiring diagram of BEV unit pasting in detail.
2 In case using central remote control, connect it to the unit in accordance with the attached installation manual.
3 X24A is connected when the infrared remote control kit is being used.
4 Remote control model varies according to the combination system, confirm engineering materials and catalogs, etc. before connecting.
5 Confirm the method of setting the selector switch (SS1, SS2) of wired remote control and infrared remote control by installation manual and engineering data, etc.
Indoor Unit S1L Float switch Receiver/Display unit (Attached to infrared remote control)
A1P Printed circuit board SS1 Selector switch (Emergency) A3P Printed circuit board
A2P Printed circuit board (Transformer 220~240V/16V) V1TR Phase controle circuit A4P Printed circuit board
C1R Capacitor (M1F) X1M Terminal strip BS1 Push button (ON/OFF)
HAP Light emitting diode (Service monitor-green) X2M Terminal strip H1P Light emitting diode (ON-Red)
M1S Motor (Swing flap) RC Signal receiver H2P Light emitting diode (Timer-Green)
M1F Motor (Indoor fan) TC Signal transmission circuit H3P Light emitting diode (Filter sign-Red)
M1P Motor (Drain pump) H4P Light emitting diode (Defrost-Orange)
Q1M Thermo switch (M1F embedded) SS1 Selector switch (Main/Sub)
R1T Thermistor (Air) SS2 Selector switch (Wireless address set)
R2T Thermistor (Coil) Connector for optional parts
RYA Magnetic relay (M1A) Wired remote control X24A Connector (Infrafed remote control)
RYP Magnetic relay (M1P) R1T Thermistor (Air) X30A Connector (Interface adapter for sky air series)
S1Q Limit switch (Swing flap) SS1 Selector Switch (Main/Sub) X35A Connector (Group control adapter)
: Terminal
: Connector
: Field wiring
COLORS : RED : Red BLK : Black
WHT : White YLW : Yellow
GRN : Green BLU : Blue