DAISHIN SRM180K Page 5
SAFETY RULES
CAUTION
Some of the illustrations show the machine with no guard, no shield. Never use the machine
without these devices.
• Learn to stop the machine in case emergency.
• Read this manual.
• Do not let anybody use the machine before having read and understood this
manual.
• Do not let children use the machine.
• Do not wear loose clothes. They might be grasped by moving parts.
• Always wear protection equipments for when using the machine.
• Only work during daylight or with a good artificial light.
• Check that the safety instruction stickers are in place and in a good condition.
• Keep the machine free from debris or mud.
• Check that the machine can work properly before any use.
• Check that all the shields, grids and safety guards are in place and in a good state.
• It is strictly forbidden to carry persons or animals onto the machine during the work or during the
transportation.
• Never stop or start roughly when working on a slope. Never use the
machine to work on a stepping terrain.
• Reduce the ground speed when running on a slope and when turning
straight in order to prevent from any risk of losing control.
• Be very careful when bordering ditches.
• Stop the engine, and remove the sparking plug ignition cover before any
intervention on the machine.
• Never work under the machine or its parts when lifted, unless they are
blocked and maintained into position with sufficient security.
• When running on a slope, always work going up or down but never
across the slope.
• Steer clear of unsteady embankments, holes or rocks. They might be dangerous during
manœuvres or transport.
• Keep away from electric wires and obstacles. A contact with electric wires cause electrocution and
death.
• Stop the machine progressively when lifting or lowering the machine.
• When stopping the work, stop the engine and remove the sparking plug ignition cover before
leaving the mower.
• Engage all the safety equipments.
• Move the controls only when correctly sat down in the mower
• Visually check hydraulic leaks and if some parts are faulty or missing. Repair before use.
• Never change the adjusment of the regulator, it is set in the factory. Unsetting this valve would
cause failures.
• Ensure that the user of the machine has already read and understood this
manual and that he is aware of all the safety instructions before any use.
• Always use a chuck and bronze hammer when replacing or intervening on
the pins and bolts at the end of rams, rod … etc in order to avoid the
projection of metal fragments.
To Next Page
Loading...