EN
Page | 42
13.4 Replacing the lamp
ELECTRIC SHOCK HAZARD!
Before replacing the lamp, switch off the appliance, remove the mains plug and
switch off or unscrew the fuse.
RISK OF BURNS!
Do not touch the lamp until the appliance has been switched off and the lamp
has cooled down completely.
Do not cover the lamp with heat insulation or other material.
Lamp data: 220-240 V, max. 4 W
Fitting: E 14
1. To replace the lamp, first remove the filter grille.
2. Unscrew the defective lamp in anti-clockwise direction.
3. Do not touch the new lamp directly with your fingers; use a clean cloth to screw in
the lamp.
4. Carefully insert the new lamp into the lamp bracket and screw tight in clockwise
direction.
5. Carefully fit the filter grille into the extractor hood again.
6. Connect the appliance to the power supply again.
To Next Page
Loading...