Why is the backup time low on my Dale Power Solutions UPS?
The backup time on your Dale Power Solutions UPS might be low because the battery is not fully charged. Recharge the battery for at least 8 hours. It could also be due to UPS overload, so check the loads and remove some if necessary. Finally, the batteries may be worn out; in that case, contact your distributor for replacement batteries.
What to do if the battery capacity indicator flashes on my Dale Power Solutions E201 UPS?
If the battery capacity indicator flashes on your Dale Power Solutions UPS, it means the battery voltage is low or the battery is disconnected. Check the UPS battery and its connections. If necessary, replace the battery.
What to do if my Dale Power Solutions E201 doesn’t start after pressing the ON keys?
If your Dale Power Solutions UPS doesn’t start after pressing the ON keys, ensure you are pressing the correct two keys at the same time. Also, check if the battery is connected. If the battery voltage is low, turn off the UPS and remove some loads before restarting it. If the problem persists, there may be an internal fault.
What to do if mains is normal, but Dale Power Solutions UPS has no input?
If the mains is normal but your Dale Power Solutions UPS has no input, the UPS input breaker may be open circuit. Reset the input breaker and ensure there is a mains supply.
How to fix flashing INPUT letters on Dale Power Solutions UPS LCD display?
If the INPUT letters on the LCD display of your Dale Power Solutions UPS are flashing, it indicates that the mains live and neutral are connected the wrong way round, or the mains is out of range. Re-connect the input power cable.
Explains safety symbols used in the manual for installation, operation, and maintenance.
Lists available E200 series models and their specifications, including external battery options.
Details core features like intelligent sine-wave output and DSP technology for the E200 series.
Provides guidelines for optimally placing the UPS unit for performance and safety.
Offers essential instructions for safe and correct wiring of the UPS and associated components.
Illustrates and labels the connections and indicators on the rear panels of E201 and E202/E203 UPS models.
Details the steps and precautions for connecting the UPS to the system and mains power.
Details the function of front panel buttons, LEDs, and the LCD panel for UPS operation and settings.
Lists critical checks and precautions to perform before turning on the UPS for the first time or after changes.
Provides step-by-step instructions for safely powering on the UPS unit.
Lists the configurable settings for the UPS, including ECO mode, Bypass mode, and Output voltage.
Describes the UPS's behavior in fault mode, including output cutoff, buzzer, and display of fault codes.
Guidelines for maximizing battery life, including temperature, discharge, and charging recommendations.
Provides a table of common UPS problems, probable causes, and solutions before contacting the distributor.
Provides a list of fault codes displayed by the UPS and their corresponding fault types.
General| Apparent Power | 2000 VA |
|---|---|
| Input Voltage | 230 V |
| Input Frequency | 50/60 Hz |
| Output Frequency | 50/60 Hz |
| Communication Interface | USB, RS232 |
| Operating Temperature | 0°C to 40°C |
| Storage Temperature | -15°C to 45°C |
| Humidity | 0-95% non-condensing |
| Battery Recharge Time | 4 hours to 90% capacity |
To Next Page
