10
English
If in doubt: Ask your DALI dealer for advice.
Connection to a stereo pre-amplifier (Fig. 7)
If you want to use Concept SUB to supplement the bass reproduction of
a stereo system, connect the subwoofer "Line in, Left/Right" to a stereo
signal on the pre-amplifier with full frequency content. The built-in cros-
sover network in Concept SUB then ensures that the subwoofer only repro-
duces the lowest frequencies (see section on adjustments on page 11).
In most cases you will achieve excellent results with one Concept SUB. It is
possible as a no-compromise stereo solution, or for reproduction of very
powerful sound pressure in a surround set-up in large rooms, to use two
Concept SUB. This solution is connected in the same way, but for stereo
you should only connect the left-hand channel to one input terminal on
the left-hand Concept SUB and the right-hand channel to one input termi-
nal on the right-hand Concept SUB. For a surround set-up, parallel the LFE-
inputs of the two Concept SUB. In all other respects, follow the instructions
above - but use separate channels. You may wish to consult your dealer.
Note: When using two Concept SUB, the best results are normally achie-
ved by positioning the two subwoofers relatively close to each other (1 - 2
metres).
Fig. 7
To Next Page
Loading...
