Dali elegance - Page 5

Always switch off your amplier before adjusting any of the cables!
5
English
The connection to your amplier is
extremely important for your sound
experience.
Always turn off your amplier before
connecting any cables or altering any
connections.
Always use cables of the same type and length for left and right speak-
ers. We recommend using speaker cables from DALI, available from your
dealer.
A detail that is often overlooked is connection in the correct phase, i.e. the
red terminal (+) on the amplier should be connected to the red terminal
(+) on the speaker, and the black terminal (-) on the amplier should be
connected to the black terminal (-) on the speaker. (Fig. 1)
For the perfect sound experience, the right speaker must be connected to
the output terminal marked "R" or "Right" on your amplier and the left
speaker to the terminal marked "L" or "Left". If just one speaker in a stereo
or surround sound system is not connected in phase, the bass will be weak
and the overall sound will be diffuse.
Surround sound ampliers have similar output terminals to stereo speak-
ers, usually labelled "Front", "Centre" and "Rear". (Fig. 3) For further infor-
mation, please refer to the manual.
You must ensure that the cable ends
are rmly pushed into the terminals,
and that there are no loose wires,
which could cause a short circuit and
damage the amplier. (Fig. 2)
Using inferior cables for your new DALI speakers is just the same as putting
cheap tyres on a thoroughbred racing car. Using cables from DALI, which
have been specially designed, will ensure a perfect sound experience.
Fig. 2. Terminal connection
Fig. 1. Stereo connection
Connection