DALI OBERON6
1.0 INTRODUCTION
Congratulations with your new DALI OBERON loudspeaker. It is important to us
that your new DALI loudspeakers are set up and connected optimally. For this
reason, we recommend that you read this manual and follow its recommendations.
The manual contains instructions for setup and connection, as well as tips and
advice on how to get the most out of your new loudspeakers.
DALI is acclaimed around the world for unique loudspeakers built to our
uncompromising standards for design and performance. The goal for every single
DALI loudspeaker is always our foremost commitment: To create a listening
experience in your home that will make you forget time and place.
Remember to sign up for the DALI newsleer at www.dali-speakers.com.
Enjoy!
2.0 UNPACKING
Be careful not to damage the contents when you unpack the parts. Depending
on which DALI OBERON model you have bought, dierent accessories come with
the loudspeaker. Check that all parts are contained in the cardboard box (see
Table 1). Keep the packaging materials should your speaker need to be relocated
or serviced.
2.1 GRILLES
The speakers are delivered with the grille fronts already mounted when you
unpack them. Remove transport protection from OBERON 1, 3, 5, 7 and 9 (See
Figure 3) before use. If you wish to remove the grille front, loosen it by gradually
tugging at the plungers that hold it in place. It is important that all plunges are
equally loosened before removing the front. Otherwise the grille may be damaged.
3.0 POSITIONING
To achieve the best results, the loudspeaker setup should be symmetrical round
your favourite listening position (see Figure 1A – C). We recommend that you
experiment with the position of your loudspeakers – the sound quali will change
depending on the loudspeaker position.
Objects positioned between the speaker and the listening position might negatively
aect sound quali.
The speakers are designed to meet our wide dispersion principle, so they should
NOT be angled towards the listening position, but be positioned parallel with the
rear wall, see Figure 2. By parallel positioning, the distortion in the main listening
area will be lowered and the room integration will be improved. The wide dispersion
principle will ensure that sound is spread evenly within a large area in the listening
room.
3.1 DALI OBERON 5, 7 & 9
The speakers are designed as floor standing speakers and they should ideally be
positioned minimum 20 cm (8”) from the rear wall.
To Next Page
Loading...
Need help?
General
