Dalla Corte DC TWO - Password (PW)

32
Inserendo la PW dello USER, quest’ultimo potrà accedere ad alcuni menù d’impostazione.
La PW di default è 0000.
When you push the button, the display will show:
1.1 - Enter
1.2 - Modify
Use or to select the ENTER item and push to enter. The display will show:
1.1.1 - User
1.1.2 - Service
Use or to select the USER item and push to enter. The display will show:
Enter 0000
To enter the PW, use or buttons – when the desired digit is reached, press .
You can change the default password through the “1.2 Modify” menu.
To restore the default password, switch off the grinder and switch it back on by pushing the three buttons
.
When you have entered the last digit, press to confirm it and to go back to the menus list.
You can scroll the menus list by using or . Just push for 3 seconds to go back to the main page.
By entering the USER’s PW, you can access some set-up menus.
The default PW is 0000.
1. Password (PW)
NOTE
If you enter the wrong password, start over and follow the above-mentioned steps again.
DC-TWO
GCS
1. Password
GCS