EasyManua.ls Logo

DAN DRYER Elite Classic 2000 User Manual

DAN DRYER Elite Classic 2000
2 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
INSTALLATION & USER INSTRUCTIONS
DAN DRYER
®
ELITE 2000 HAIR DRYER
Enclosed with the hair dryer are the installation instructions as well as a small
plastic bag containing:
2 pcs. screws
2 pcs. rawlplugs
2 pcs. washers
1 pcs. plastic cap
1 pcs. wall mounting bracket
PRIOR TO INSTALLATION:
Before installing the hair dryer, please check that the power supply has
sufficient capacity to handle the extra wattage specified on top of the dryer
housing.
Be sure to install the unit right next to a mirror, if any, thus preventing users
from stretching the flexible hose to the breaking point in the attempt to look at
themselves in the mirror.
The hair dryer is double-insulated and thus needs no earth connection.
FIXED WALL MOUNTING:
Disassemble cover plate by removing the in Fig. 1 with A marked screw.
Attach unit to the wall, using the two holes marked with screws and
rawlplugs.
Mark and drill two 6 mm holes in the wall, vertically underneath each other
and 198 mm apart (Fig. 2). Recommended installation height from the floor
to the top edge of the dryer is 180 cm.
Feed supply cable through the cable inlet hole at the top right corner and
connect to terminal block. Attach dryer housing using the screws and
washers enclosed (Fig. 3).
IMPORTANT
Reassemble cover plate before test running the hair dryer.
Fixed installation must be carried out by a qualified electrician.
The ELITE hair dryer complies with the EU directive 87/308 on the reduction of
electromagnetic interference.
Question and Answer IconNeed help?

Do you have a question about the DAN DRYER Elite Classic 2000 and is the answer not in the manual?

DAN DRYER Elite Classic 2000 Specifications

General IconGeneral
Motor TypeAC
Speed Settings2
Cool ShotYes
ActivationButton
Frequency50Hz

Summary

Installation and User Instructions for Dan Dryer Elite 2000

Prior to Installation Checks

Check power supply capacity and unit placement near a mirror. Unit is double-insulated.

Fixed Wall Mounting Guide

Steps for wall mounting, including drilling holes, feeding the cable, and attaching the dryer housing.

Important Installation Notes

Reassemble cover before testing. Fixed installation must be carried out by a qualified electrician.

Hair Dryer User Operation

How to activate, operate, and maintain the hair dryer safely and effectively.

Hair Dryer Maintenance

Instructions for cleaning the plastic parts of the hair dryer using mild solutions.

Model Variants and Features

Information about the SHAVER model with a 115-230 V shaver plug for electric razors.

WEEE Recycling and Disposal

Information regarding WEEE regulations for recycling and proper disposal of electronic equipment.