Danby DAC12010E User Manual (English)

Questions and Answers:

C
Clinton CollinsAug 3, 2025
Why is my Danby Air Conditioner not cooling properly?
- C
  chenanneAug 3, 2025
  If your Danby Air Conditioner isn't cooling efficiently, several factors could be the cause. It might be due to a dirty air filter, which requires cleaning or replacement. The unit size might be inappropriate for the room, so check with your dealer to ensure it's the right capacity. Also, ensure that airflow isn't blocked by obstructions on the grill or outdoor louvres. Finally, a power interruption or compressor overload could be the issue; try turning the unit off and waiting 5 minutes before restarting.
C
Cathy PaulAug 8, 2025
How to fix a Danby DAC12010E that won't turn on?
- J
  Jessica LopezAug 8, 2025
  If your Danby Air Conditioner isn't turning on, there could be a few reasons. First, check that the power cord is properly connected to the power source. Also, inspect the fuse or circuit breaker. Ensure the SELECTOR SWITCH is set to a position other than “OFF”. Finally, make sure the power cord “RESET” button is pushed in (engaged).
R
Richard CamposAug 12, 2025
Why is my Danby DAC12010E Air Conditioner dripping water inside?
- S
  Stephanie PittmanAug 12, 2025
  If water is dripping inside from your Danby Air Conditioner, it's likely that the unit isn't properly angled to allow water to drain outside. The unit must be installed on an angle for proper condensation run-off, so check the unit and make any necessary adjustments.
J
Jennifer PerezAug 16, 2025
Why does my Danby DAC12010E Air Conditioner have ice or frost build-up?
- E
  Emma KnightAug 16, 2025
  If you notice ice or frost build-up on your Danby Air Conditioner, it could be due to a couple of reasons. If the outside temperature is around 18.3°C (65°F) or below, frost may form when the unit is in cooling mode; switch to FAN-only operation until the frost melts. Another cause might be a dirty air filter; remove and clean it.
J
john95Aug 21, 2025
Why is my Danby Air Conditioner dripping water outside?
- E
  eromeroAug 21, 2025
  If your Danby Air Conditioner is dripping water outside, it is likely due to hot and humid weather. Condensation run-off is normal under these conditions.
C
Cheryl PotterAug 25, 2025
How to reduce noise from my Danby DAC12010E?
- J
  Julie HernandezAug 26, 2025
  A noisy Danby Air Conditioner could be due to loose parts; try tightening them. Alternatively, the unit may lack adequate support; provide additional support to the unit.
B
blairjeremyAug 29, 2025
What to do if my Danby DAC12010E Air Conditioner smells bad?
- B
  Brandon TorresAug 29, 2025
  If your Danby Air Conditioner is emitting odors, it's likely due to the formation of mold, mildew, or algae on wet surfaces. To resolve this, clean the unit thoroughly. You can also place an algaecide tablet in the base pan.

Danby DAC12010E Specifications

General

Type	Portable Air Conditioner
Cooling Capacity	12, 000 BTU
Room Size Coverage	Up to 550 sq. ft.
Refrigerant	R410A
Fan Speeds	3
Display Type	LED
Filter Type	Washable
Voltage	115 V
Operating Voltage	115 V
Operating Frequency	60 Hz