Danby DAC5277EE - Page 7

1. Preparation to Remove the Air Conditioner
Slide-Out Chassis
• Position the air conditioner in the normal
(upright) position,
• Remove the air filter by grasping the filter handle
(on front grill) and sliding it to the right.
• Remove the phillips screw (behind filter)
securing the grill front to the chassis. (Fig. 3)
• Remove the phillips screws located on the (lower
left/right) edge of front grill. (Fig.1)
• To remove the front grill, grasp the lower front
corner of the grill, pulling (gently) outward and
upward. (Fig.3)
Repeat this step on the 3 remaining corners.
• Before the front grill can be completely removed
from the cabinet, it will be necassary to
disconnect the (male/female) electrical wire
harness located directly behind the front grill.
(Fig 4)
• Remove the two phillips screws (lower left/right
side of cabinet) securing the slide-out-chassis to
the cabinet. Fig.6
NOTE: These screws must be reinstalled
upon completion of the window installation.
(to secure slide-out-chassis)
NOTE: Some models may be inclusive of an
additional (slide-out chassis) retaining bracket and
screw located at the front of the chassis. This
bracket and screw must also be removed before
attempting to remove the slide-out chassis. Fig. 5
• Grasp the pull handle at the front of the slide-out-
chassis and carefully slide the air conditioner out
of the cabinet. (Fig.5)
Please seek assistance for this procedure.
6