6
REMOTE CONTROL
1. Power button: Press to turn the fi replace and fl ame on or off.
2. Heater button: Press repeatedly to select low or high heat mode.
3. Flame button: Press to turn the fl ame on or off and to change the
fl ame colour.
4. Ember bed button: Press to turn the carbon bed on or off and to
change the colour.
5. Timer button: Press repeatedly to set the timer. The timer will turn the
fi replace off after the chosen time. The timer can be set in 1/2 hour
increments up to 7.5 hours.
6. Light button: Press to adjust the fl ame brightness. There are 5
brightness levels.
1
2
3
5
6
4
OPERATING INSTRUCTIONS
To Next Page
Loading...
