Danby DDR60B3WP User Manual (English)

Questions and Answers:

M
Madison FosterAug 4, 2025
Why won't my Danby DDR60B3WP Portable dehumidifier start?
- B
  Brandon GonzalezAug 4, 2025
  If your Danby Portable dehumidifier isn't starting, several factors could be at play. First, ensure the dehumidifier is properly plugged into the outlet. Check your house fuse or circuit breaker and replace the fuse or reset the breaker if needed. The dehumidifier might have reached its preset level or the bucket could be full; in this case, change to a lower setting or empty the bucket and replace it correctly. Ensure the bucket is securely seated for the unit to operate. Also, be aware that there is a protective time delay of up to 3 minutes to prevent tripping the compressor overload, so the unit may not start immediately after being turned back on.
L
Lauren PageAug 8, 2025
How to improve drying performance of Danby DDR60B3WP Portable dehumidifier?
- H
  Heather MurrayAug 8, 2025
  If your Danby Portable dehumidifier isn't drying the air adequately, consider these points. When first installed, allow at least 24 hours to achieve the desired dryness. Ensure no curtains, blinds, or furniture are blocking the front or back of the unit. Clean the air filter. Set the humidity control to a lower percent value for drier air. Verify that all doors, windows, and other openings are securely closed. Position the dehumidifier away from the clothes dryer, and ensure the dryer is vented to the outside. Remember that moisture removal is most effective at higher room temperatures, as lower temperatures reduce the rate of moisture removal; the dehumidifier is designed to operate above 5°C (41°F).
C
Christina ZimmermanAug 14, 2025
Why does my Danby DDR60B3WP Portable dehumidifier run constantly?
- M
  Mary DaltonAug 14, 2025
  If your Danby Portable dehumidifier is running excessively, it might be due to a couple of reasons. The area you're trying to dehumidify might be too large for the unit's capacity. Alternatively, open doors and windows can also cause the dehumidifier to run more than necessary. Make sure to close all doors and windows to see if that resolves the issue, and consider that the capacity of your dehumidifier may not be adequate.
S
scottbuckleyAug 19, 2025
What to do if there is water on the floor near my Danby DDR60B3WP?
- S
  Stephen MccarthyAug 19, 2025
  If you find water on the floor near your Danby Portable dehumidifier, it could be due to a loose hose connection. Check the hose connection to ensure it's properly secured. If you're using the bucket to collect water, make sure the hose is disconnected.
T
Todd JohnsonAug 23, 2025
Why can't I set the controls on my Danby DDR60B3WP Portable dehumidifier?
- J
  jenniferwarrenAug 25, 2025
  If you're having trouble setting the controls on your Danby Portable dehumidifier, it might be because the compressor turns off, but the fan continues to run automatically for about 3 minutes at a fixed setting. This is normal operation. Wait approximately 3 minutes, and then you should be able to set the fan as desired.
A
Abigail GrahamAug 29, 2025
Why is there frost on the coils of my Danby DDR60B3WP?
- C
  cynthialopezAug 29, 2025
  If you notice frost on the coils of your Danby Portable dehumidifier, especially soon after turning it on or if the room temperature is below 5°C (41°F), it's generally normal. The frost should disappear within about 60 minutes.

Danby DDR60B3WP Specifications

General

Model	DDR60B3WP
Type	Portable dehumidifier
Dehumidification Capacity	60 pints per day
Energy Star Rated	Yes
Noise Level	51 dB
Continuous Drain Option	Yes
Refrigerant	R410A
Automatic Defrost	Yes
Control Type	Electronic
Display Type	Digital
Fan Speeds	2
Voltage	115V
Color	White
Coverage Area	3, 800 sq. ft
Filter Type	Washable filter
Drainage Option	Manual or Continuous

Summary

Safety and Important Instructions

Do Not Return Unit to Retailer

Instructs users not to return the unit to the retailer without further manufacturer instructions.

Grounding Method

Details the importance and method of proper unit grounding for electrical safety.

Safety Instructions and Electrical Requirements

Covers general safety rules, electrical requirements, and grounding instructions for safe operation.

Welcome and Getting Help

Provides a welcome message and guidance on seeking assistance before calling for service.

Installation and Features

Location Requirements

Specifies ideal placement criteria for optimal dehumidifier performance and airflow.

Product Features

Lists and briefly describes the main components and parts of the dehumidifier.

Operating the Dehumidifier

Control Panel and Operation Modes

Explains the function of each button on the control panel and how to select operating modes.

Indicator Lights and Error Codes

Details the meaning of indicator lights and provides solutions for common error codes.

Water Tank and Dehumidifying Process

Explains water tank operation, the dehumidifying process, and mode selection for optimal performance.

Air Filter Maintenance

Guides on cleaning and maintaining the air filter for efficient operation and unit longevity.

Removing Collected Water

Provides instructions for manually emptying the water bucket and setting up continuous draining.

General Operating Cautions

Lists important safety cautions to follow during the operation of the dehumidifier.

Care and Maintenance

Cleaning Instructions

Details how to clean the unit's exterior, water bucket, and air filter, including important precautions.

Troubleshooting

Problem Resolution Guide

Offers solutions for common issues such as the unit not starting or not drying effectively.

Warranty Information

Warranty Terms and Exclusions

Outlines the warranty period, terms, conditions, and exclusions for the appliance.

Related product manuals

Danby DDR60B3WP User Manual

Table of Contents