EasyManua.ls Logo

Danby DDR70B3WP - User Manual

Danby DDR70B3WP
48 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
DANBY PRODUCTS LIMITED, ONTARIO, CANADA N1H 6Z9
DANBY PRODUCTS INC., FINDLAY, OHIO, USA 45840
2:1(5¶686($1'&$5(*8,'(
*8,'('¶87,/,6$7,21(7'(175(7,(1
*8Ë$'(87,/,=$&,Ï1<&8,'$'23$5$(/3523,(7$5,2
02'(/02'Ê/(02'(/2
)25<2856$)(7<Read these instructions carefully before operating the unit.
32859275(6e&85,7eLire attentivement ces instructions avant d’utiliser l’appareil.
3$5$686(*85,'$'Lea y observe todas las reglas de seguridad y las instrucciones de operación antes
de usar este producto.
(1*/,6+
PORTABLE DEHUMIDIFIER
DESHUMIDIFICATEUR PORTATIF
DESHUMIDIFICADOR PORTÁTIL
DDR60B3WP
DDR70B3WP
18.11.14
To Buy: Visit www.sylvane.com or call (800) 934-9194
For Product Support: Contact Danby at 1-800-263-2629

Table of Contents

Questions and Answers

  • J
    joshua77Aug 8, 2025
    Why won't my Danby DDR70B3WP start?
    • S
      sara81Aug 8, 2025
      If your Danby Portable dehumidifier isn't starting, several factors could be at play. First, ensure the dehumidifier is properly plugged into the outlet. Check your house fuse or circuit breaker and replace the fuse or reset the breaker if needed. The dehumidifier might have reached its preset level or the bucket could be full; in this case, change to a lower setting or empty the bucket and replace it correctly. Ensure the bucket is securely seated for the unit to operate. Also, be aware that there is a protective time delay of up to 3 minutes to prevent tripping the compressor overload, so the unit may not start immediately after being turned back on.
  • M
    Mr. Ryan GillespieAug 13, 2025
    How to improve drying performance of Danby DDR70B3WP?
    • L
      lmillerAug 13, 2025
      If your Danby Portable dehumidifier isn't drying the air adequately, consider these points. When first installed, allow at least 24 hours to achieve the desired dryness. Ensure no curtains, blinds, or furniture are blocking the front or back of the unit. Clean the air filter. Set the humidity control to a lower percent value for drier air. Verify that all doors, windows, and other openings are securely closed. Position the dehumidifier away from the clothes dryer, and ensure the dryer is vented to the outside. Remember that moisture removal is most effective at higher room temperatures, as lower temperatures reduce the rate of moisture removal; the dehumidifier is designed to operate above 5°C (41°F).
  • S
    Stephanie BaileyAug 17, 2025
    Why does my Danby DDR70B3WP Portable dehumidifier run constantly?
    • C
      chavezscottAug 18, 2025
      If your Danby Portable dehumidifier is running excessively, it might be due to a couple of reasons. The area you're trying to dehumidify might be too large for the unit's capacity. Alternatively, open doors and windows can also cause the dehumidifier to run more than necessary. Make sure to close all doors and windows to see if that resolves the issue, and consider that the capacity of your dehumidifier may not be adequate.
  • S
    Steven ClarkAug 22, 2025
    What to do if there is water on the floor near my Danby Portable dehumidifier?
    • C
      Cassandra SmithAug 22, 2025
      If you find water on the floor near your Danby Portable dehumidifier, it could be due to a loose hose connection. Check the hose connection to ensure it's properly secured. If you're using the bucket to collect water, make sure the hose is disconnected.
  • B
    bheathAug 27, 2025
    Why can't I set the controls on my Danby DDR70B3WP Portable dehumidifier?
    • M
      Melissa GarciaAug 27, 2025
      If you're having trouble setting the controls on your Danby Portable dehumidifier, it might be because the compressor turns off, but the fan continues to run automatically for about 3 minutes at a fixed setting. This is normal operation. Wait approximately 3 minutes, and then you should be able to set the fan as desired.
  • J
    Jenny JohnstonSep 2, 2025
    Why is there frost on the coils of my Danby DDR70B3WP Portable dehumidifier?
    • A
      amanda15Sep 2, 2025
      If you notice frost on the coils of your Danby Portable dehumidifier, especially soon after turning it on or if the room temperature is below 5°C (41°F), it's generally normal. The frost should disappear within about 60 minutes.

Summary

Grounding Method

Important Safety Information

Electrical Requirements

Details electrical requirements for safe operation and wiring standards.

Grounding Instructions

Explains proper grounding procedures for electrical safety.

Installation Instructions

Operating Instructions

Water Tank Operation

Air Filter

Removing Collected Water

Procedures for emptying the water bucket or setting up continuous drainage.

Control Panel Instructions

Error Codes

Lists and explains error codes and their troubleshooting solutions.

Dehumidifying Process

Dehumidifying Mode Instructions

Care and Maintenance

Cleaning

Troubleshooting

Limited Carry-In Appliance Warranty

Terms of Warranty

Details the warranty period and conditions for functional parts.

Danby DDR70B3WP Specifications

General IconGeneral
TypePortable Dehumidifier
Capacity70 pints per day
Energy Star RatedYes
Noise Level51 dB
Automatic DefrostYes
Automatic Humidistat ControlYes
RefrigerantR410A
Voltage115 V
ColorWhite
Filter TypeWashable filter

Related product manuals