EasyManua.ls Logo

Danby DDW1801MWP - Care and Maintenance Practices; Routine Cleaning and Holiday Prep; Protecting Against Freezing

Danby DDW1801MWP
44 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Troubleshooting
Problem Possible Cause Solution
Dishwasher
doesn’t run
• Fuse blown or circuit breaker has tripped
• Power supply is not turned on
• Water pressure is low
• Replace fuse or reset circuit breaker
• Make sure dishwasher is turned on and door is
closed. Plug in cord securely
• Check that water supply is connected and the
water is turned on
Drain pump
doesn’t stop
• Overfl ow • The system is designed to detect an overfl ow.
When it does, it shuts off the circulation pump
and turns on the drain pump
Noise • Some audible sounds are normal
• Utensils are not secure in basket / some-
thing small has dropped into the basket
• Motor hums
• Sounds from soft food shredding action and
detergent cup opening
• Ensure everything is secured in the dishwash-
er
• If you do not use often, dishwasher may hum,
remember to fi ll and pump out the appliance
every week to keep the seal moist
Suds in the tub • Improper detergent
• Spilled rinse agent
• Use only dishwasher detergent to avoid suds.
If suds are present, open the door and let suds
evaporate
• Always wipe rinse agent spills immediately
Dishes are not dry • Rinse agent dispenser is empty • Make sure that the rinse agent dispenser is
fi lled
Dishes and fl at-
ware are not clean
(spots / fi lming)
• Improper program selected / run
• Improper rack loading
• Extremely hard water
• Select a stronger program
• Make sure that the detergent dispenser and
spray arms are not blocked by large dishware
• Remove all metal utensils from dishwasher,
see “Removing Hard Water Spots from Dishes”
section
Detergent left in
dispenser cups
• Dishes blocking the detergent cups • Re-load the dishes properly
Water standing in
the bottom of the
tub
• This is normal • A small amount of clean water around the out-
let at the back of the tub keeps the water seal
lubricated
Water doesn’t
pump out of the
tub
• The drain is clogged • Make sure the kitchen sink is draining well. If
the dishwasher drains into a disposer, run it
clear
Dishwasher leaks
/ steams
• Overfi lled dispenser or rinse aid spills
• Dishwasher isn’t level
• Steam is normal
• Be careful not to overfi ll the rinse aid dispense.
Spilled rinse aid can cause over sudsing and
lead to overfl owing. Wipe away any spills with
a damp cloth
• Make sure the dishwasher is level
• Steam coming through the vent by the door
latch is normal during drying and water drain-
ing
Occasionally a problem may arise that is minor in nature and a service call may not be necessary. Use this troubleshoot-
ing guide for a possible solution. If the unit continues to operate improperly, call an authorized service depot or Danby’s
toll free number for assistance.
1-800-26-DANBY
(1-800-263-2629)
11