Danby DPAC9009 - Dehumidifier Mode; Fan Mode

OPERATING INSTRUCTIONS (cont’d)
8
DEHUMIDIFIER
Note: During dehumidifier mode, the exhaust hose
does not have to be vented outdoors.
1) Press the ON/OFF key pad to switch the unit on
(Fig. G)
2) Press the MODE key (Fig. H) until the DRY
indicator illuminates on the control panel (Fig.I).Each
press of the MODE key will advance to a different
mode setting (Cool-Dehumidifier-Fan-Heat-Auto).
IMPORTANT: There is no fan speed or temperature
adjustment during dehumidifier mode. The fan speed
is factory set for Low and the dehumidifier operates
continuously (non-stop) regardless of ambient
humidity level or set temperature.
FAN
NOTE: During Fan Mode, the exhaust hose
does not have to be vented outdoors.
1) Press the ON/OFF key pad to switch the unit on
(Fig. G).
2) Press the MODE key (Fig. H) until the FAN
indicator illuminates on the control panel (Fig. J).
Each press of the MODE key will advance to a
different mode setting (Cool-Dehumidifier-Fan-Heat-
Auto).
3) Press the FAN Key (Fig. K) to select the desired
FAN SPEED setting. Your selection will appear on
the control panel. Each press of the fan key will
advance to a different fan speed (High- Med- Low)
as shown in Fig. L.
Fig. J
Fig. H
Fig. G
Fig. I
Fig. K
Fig. L