Danby DVAC10038E User Manual (English)

Questions and Answers:

A
ariel51Jul 31, 2025
Why is my Danby Air Conditioner not cooling efficiently?
- S
  Sophia HillJul 31, 2025
  Inefficient or no cooling in your Danby Air Conditioner can occur due to several reasons. It could be a dirty air filter, which requires cleaning or replacement. The unit size might be inappropriate for the room, so check with your dealer to determine the correct capacity. Blocked airflow from obstructions on the grill or outdoor louvers can also cause this, so remove any obstructions. In addition, power interruptions, settings changed too quickly, or a tripped compressor overload can be the cause. In this case, turn the unit off and wait 5 minutes before attempting to restart it.
D
Daniel OrtizAug 4, 2025
What to do if my Danby DVAC10038E Air Conditioner won't turn on?
- Y
  Yvette RiceAug 5, 2025
  If your Danby Air Conditioner isn't turning on, the issue might be related to the power supply. Check if the power cord is properly connected to the power source. Also, inspect the fuse or circuit breaker to ensure they are functioning correctly.
N
Natalie JohnsonAug 10, 2025
What to do if my Danby DVAC10038E Air Conditioner is dripping water inside?
- C
  Carrie AlvaradoAug 10, 2025
  If your Danby Air Conditioner is dripping water inside, it's likely not properly angled to allow water to drain outside. The unit must be installed on an angle for proper condensation run-off, so check the unit and make any necessary adjustments.
J
Jeremiah OrtegaAug 15, 2025
What to do if my Danby DVAC10038E Air Conditioner is building up ice or frost?
- J
  Jorge ShahAug 15, 2025
  Ice or frost buildup in your Danby Air Conditioner can happen due to a low outside temperature. When the outdoor temperature is approximately 65°F or below, switch the unit to FAN-only operation until the frost melts. Another cause can be a dirty air filter, so remove and clean it.
K
Kayla LeeAug 20, 2025
Why is my Danby DVAC10038E Air Conditioner so noisy?
- M
  Melvin MoranAug 20, 2025
  A noisy Danby Air Conditioner could be due to loose parts, which you should tighten. It might also be caused by inadequate support, so provide additional support to the unit.
A
Amy CalderonAug 25, 2025
How to get rid of odors from my Danby DVAC10038E?
- A
  adam72Aug 26, 2025
  Odors from your Danby Air Conditioner are likely due to the formation of mold, mildew, or algae on wet surfaces. To resolve this, clean the unit thoroughly and place an algaecide tablet in the base pan.

Danby DVAC10038E Specifications

General

Type	Portable Air Conditioner
Cooling Capacity	10, 000 BTU
Voltage	115V
Amperage	9.5 A
Noise Level	52 dB
Coverage Area	450 sq. ft.
Power Supply	115V / 60Hz
Dehumidification Capacity	54.9 Pints/24 hours
Refrigerant	R32