Why is my Danby Premiere DPAC 13009 not cooling the room?
If your Danby Air Conditioner isn't cooling the room, several factors could be the cause. Check if any windows or doors are open and close them. Remove any heat sources from the room, and ensure the air intake grill is clean. Also, replace the filter if it's dirty and lower the temperature setting.
Why does my Danby Premiere DPAC 13009 suddenly stop?
Your Danby Air Conditioner might suddenly stop for a few reasons. The indoor set temperature might have been reached, so reset the temperature level. Alternatively, the preset timer could be up, requiring you to reset it. Also, check if the full-tank indicator is on, indicating that the drain tank is full and needs to be emptied.
What to do if condensed water spills when moving my Danby Premiere DPAC 13009?
If condensed water spills out when moving your Danby Air Conditioner, it's likely that the tank is nearly full. To resolve this, remove the drain plug on the rear bottom of the unit and drain out the water.
Why does my Danby Premiere DPAC 13009 run intermittently?
Your Danby Air Conditioner might run intermittently because the surrounding temperature is too high or too low, which is normal. Also, check the exhaust duct hose to make sure it is not blocked.
What to do if my Danby Premiere DPAC 13009 Air Conditioner stops working?
If your Danby Air Conditioner isn't working, first, make sure there isn't a power outage. Then, check if the plug is properly inserted. If the full-tank indicator is on, remove the drain water from the drain tank. Finally, if there's a current leak or the test button on the LCDI plug was pressed, press the reset button after resolving the issue.
Details electrical requirements, wiring, grounding, and plug specifications for safe operation.
Explains the function and testing of the power cord's safety features for fire risk reduction.
Outlines the steps for installing the window kit for air conditioning mode.
Instructions for operating the unit in air conditioning mode, including hose venting.
Instructions for operating the unit in dehumidifier mode, noting hose requirements.
Instructions on how to remove, clean, and replace the air filter for optimal performance.
General| Type | Portable Air Conditioner |
|---|---|
| Cooling Capacity | 13, 000 BTU |
| Room Coverage | Up to 550 sq. ft. |
| Operating Modes | Cool, Fan, Dehumidify |
| Fan Speeds | 3 |
| Noise Level (Low Fan Speed) | 52 dB |
| Voltage | 115V |
| Window Kit Included | Yes |
| Remote Control | Yes |
| Timer | 24-hour |
| Filter Type | Washable |
| Refrigerant | R410A |
| Power Cord Length | 6 ft |
To Next Page