DW DANCING POKE INSTRUCTION MANUAL
How to Assemble
0.01 Apply the glue on the side of the wing, and join
together, and then insert the �iberglass reinforce-
ment into the slot on wing.
0.02 Assemble another wing by the same above way.
0.03 Insert the servo into the slot on the back of the
wing, meantime insert and glue the servo wire into
the wing, �inally pass through the middle of the wing.
0.04 Make a cut by knife in an upright position with
servo, insert the hinges and �ix by glue. Connect the
servo and servo horns on aileron by steel wire.
0.05 Assemble the 2pcs front landing gears as
picture shows below, �ix wheels with screws (E1)
,and paste the wheel cowling.
To Next Page
Loading...