DW DANCING POKE INSTRUCTION MANUAL
0.06 Insert and glue the 2pcs landing gears into
slots as picture show.
0.07 Insert the horizontal tail into the rear of the
fuselage, and �ix by glue.
0.08 Apply the glue on the side of the vertical tail,
adjust and maintain the level with fuselage, �inally
join together by glue.
0.09 Glue the back landing gear parts and punch
holes on the wooden board as per the wheel screw
holes; �inally assemble the back landing gear.
0.10 Assemble the servos into the servo slots inside
the fuselage and �ix with screws.
0.11 Insert the servo steel wires into the slot on the
fuselage as picture shows below, one at either side
of the fuselage.
0.12 Con�irm the position of the steel wire comes
out, make cuts on the horizontal and vertical wing
by knife, insert the servo horns and �ix by glue.
To Next Page
Loading...