25
1. Power On
Click the Power ON/OFF
button, the power comes on and
MEIZU logo appears.
Using Buttons
Click
Press the Power ON/OFF button again,
start to play. If it displays no file, pls run
Update Music Library (Detail see to 30
Update the Music Library.)
2. Power Off
When you press and hold the power
ON/OFF button for about 3 seconds,
the power turns off. If the PC and the
player are connected via a USB cable,
you cannot turn the power off.
3. Playback & Stop
Press ON/OFF briefly, start to play.
Press it again while in Play status,
the play stops.
Quick Start
3
24
Saving Files and Disconnecting to your PC
Copy the Files in the Player into your PC
1. With the USB cable, connect the USB ports of the player and your PC.
(It should not use a USB hub. It is assumed that you connect to the USB port on
the main board.)
2. Save the music files under the hard disk on your PC.
3. After saved the files, click the icon on the screen of your PC.
4. It pops the message as above, then click it.
5. It runs 'Safely Remove Hardware'.
6. Then draw out and disconnect the USB cable.
To make sure to save the data on your player safely and fully, please follow
the above steps accordingly when you disconnect the player to the PC.
While disconnecting,,it appears the warning, click OK and finish it.
Saving Files & Disconnecting to Your PC
Click
Long Click
To Next Page
Loading...
Need help?
General
