What to do if the Danfoss Fan shows a fire alarm?
If the Danfoss Fan system's temperature sensor detects a temperature higher than +70°C, examine all rooms and leave the premises. If there is no longer an emergency and the system is ready for operation, shut down the ventilation system and switch the power on again to resume normal operation by disconnecting and reconnecting the power cable.
How to fix a 'Filter error' alarm on my Danfoss Fan?
The alarm indicates that the air filters are dirty. Replace the air filters following the instructions in chapter 3.1.
General| Air flow | 2800 m3/h |
|---|---|
| Protection class | IP44 |
| Voltage | 230 V |
| Frequency | 50 Hz |
| Power supply | 230 V AC |
Command to reduce air volume to a minimum for prolonged absences.
Cooling function opening a passage parallel to the heat exchanger.
Displays present status of the unit, including temperatures and fan steps.
Increases air volume for specific situations like parties or cooking.
Change ventilation control: Manual, Demand, or Program modes.
Visual representation of the user interface navigation hierarchy.
Customize system demands via default settings and weekly programs.
Step-by-step instructions for replacing air filters.
Procedures for internal cleaning of the ventilation unit.
Instructions for replacing batteries in the Air Dial remote control.
Details on standard G4 and optional G4/F7 pollen filter sets.
Remote control and customization of the Danfoss Air system via PC.
Information on electric preheating surfaces.
To Next Page
