EasyManua.ls Logo

Danfoss AK-PI 200 - User Manual

Danfoss AK-PI 200
8 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
REFRIGERATION AND
AIR CONDITIONING
Protocol interface
AK-PI 200
Manual

Table of Contents

Question and Answer IconNeed help?

Do you have a question about the Danfoss AK-PI 200 and is the answer not in the manual?

Danfoss AK-PI 200 Specifications

General IconGeneral
Analog inputs2
ProtocolModbus RTU
Operating temperature-10°C to +55°C
EnclosureIP20
CommunicationRS-485

Summary

Introduction to AK-PI 200

Function of the Protocol Interface

Describes the AK-PI 200 as an intermediary link allowing AKC and AKL controllers to be operated via a system manager.

Application Scenarios

TCP;IP Connection Principle

Details the TCP/IP connection between the system manager and AK-PI 200, discussing static vs. dynamic IP addresses.

Controller Addressing and Capacity

IP Address Configuration

Explains setting IP addresses for system manager and AK-PI 200, covering static vs. dynamic options.

Controller Address Management

Installation Procedure

Preparing Controllers on DANBUSS

TCP;IP Connection Setup

Details physical connection methods and software settings for establishing a TCP/IP connection.

System Manager and AK-PI 200 Preparation

Steps to set up the system manager and the AK-PI 200, including addressing and network configuration.

Initial System Scan and Interconnection

Ordering and Technical Data

Product Ordering Information

Technical Specifications

Provides key data including supply voltage, power consumption, ambient temperature, and enclosure details.