Danfoss AK-PI 200 - Page 7

AK-PI 200 Manual RS8EX202 © Danfoss 02-2009 7
Examples of IP addresses
The overview display will show the following:
• The address of the system manager that AK-PI 200 is connected
to
• The status of the alarm transmission
• Date and time
• The quality of the DANBUSS communication signal
The conguration display gives access to the following:
• The conguration lock is only used if a static IP address is to be
set.
• Under "System setup" you can give the unit a name
• IP settings can be entered