Danfoss DHP-A User Guide

Message Meaning
ROOM Shows the set ROOM value. Standard value: 20°C.
If the room sensor (accessory) is installed it shows the actual temperature, while the
desired indoor temperature is shown in brackets.
START Indicates that there is a need for heat or hot water production and that the heat
pump will start.
EVU STOP Indicates that the additional function EVU (Elektrizitätsversorgungsunternehmen) is
active. This means that the heat pump is off as long as EVU is active.
NO HEAT DEMAND Indicates that there is no demand for heating or hot water production.
HEAT PUMP START --
XX
Indicates that there is a need for heat or hot water production and that the heat
pump will start in XX minutes.
HEAT PUMP
+ADD.HEAT
Indicates that heat production is active with both compressor and immersion heater.
START_MIN Indicates that there is a demand for heating or hot water production but that a start
delay is active.
ADD. HEATER Indicates that there is an auxiliary heater demand.
COOLING Displayed when passive cooling is produced.
ACTIVE COOLING Displayed when active cooling is produced..
DEFROST X(Y) Displayed when defrosting is active. X shows the actual temperature reached. Y
shows at which temperature defrost is complete (applies to DHP-A ).
4.4 Main Menu
The display's INFORMATION menu is used to set and adjust the heat pump functions and is opened by pressing
the left or right button. The menu has the following appearance:
INFORMATION
OPERAT.
HEAT CURVE
TEMPERATURE
OPERAT. TIME
DEFROST
2
1
3
4
1 Sub-menus
2 Return
3 Cursor
4 If an arrow is shown, it indicates that there are further sub menus
Use the + and - buttons to move the cursor between the sub-menus. Use the right button to select a sub-menu.
Use the left button to go back in the menu.
User Guide
Domestic heat pumps
Danfoss Heating Solutions VUGFE102
13

Danfoss DHP-A Specifications

General

Brand	Danfoss
Model	DHP-A
Category	Heat Pump
Language	English