Danfoss DHP-H Varius Pro+ User Manual

6.1.3 Testing the compressor
1. Enable the compressor by pressing (manual enable).
2. Set compressor gear.
3. Check that there is no abnormal noise.
4. Check that the pressure pipe becomes hot.
5. Stop the compressor by pressing
(manual enable).
6.1.4 Exiting manual test
To exit manual test:
1. Press on the Start screen to open the Menu screen.
2.
Press on Settings
.
3.
Press
to go to the menu page for Manual test.
4. Press on the text Manual test.
5. Press
to exit manual test.
The symbol disappears.
6.1.5
Insulating pipes
When the manual test is completed, a check for leaks should be carried out. When the leakage check has been successfully completed,
the pipes should be insulated.
Caution Ensure that the pipes which transport cold water are properly insula-
ted to prevent condensation damage.
Commissioning DHP-H Varius Pro+/DHP-L Varius Pro+
Danfoss Heating Solutions VIJSG202
25

Danfoss DHP-H Varius Pro+ Specifications

General

Brand	Danfoss
Model	DHP-H Varius Pro+
Category	Heat Pump
Language	English