Symbol Description
Operating mode On. All activated functions are on.
In this operating mode, functions enabled in Settings can be switched activated or deactiva-
ted.
Press to go to page 2 where functions can be activated/deactivated.
See the example in the table below.
Operating mode On. All activated functions are on.
In this operating mode, functions enabled in Settings can be switched activated or deactiva-
ted.
Immersion heater enabled but not activated.
Press
to go to page 2 where functions can be activated/deactivated.
See the example in the table below.
The list below shows examples of selected functions on page 2 in Op-
erating mode.
Functions not activated from factory must be enabled in Settings be-
fore they can be activated and used.
Symbol Description
Operating mode Heat production. Space heating is permitted.
Operating mode Hot tap water. Hot tap water production is permitted.
7.4 System information
Check applicable operating data described in the tables below. The information can be found in the sub-menu System information
Select System information on the Menu screen:
1. Press
on the Start screen to open the Menu screen.
2.
Press System information
Operating data
Sensor
Explanation
Outdoor Shows the temperature on the outdoor sensor.
System supply line Optional. Depending on system application.
Desired supply line Shows the calculated requirement value for the supply line.
Hot water Shows the temperature of the hot water sensor, if hot water production is permitted.
Commissioning DHP-H Varius Pro+/DHP-L Varius Pro+
VIJSG202 Danfoss Heating Solutions
28
To Next Page
Loading...
Need help?
General
