EasyManua.ls Logo

Danfoss EKC 361

Danfoss EKC 361
16 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
EKC 361 Manual RS8AE802 © Danfoss 12-2009 9
Data
Ordering
Type Function Code No.
EKC 361 Evaporating pressure controller 084B7060
EKA 174
Data communication module
(accessories), (RS 485 module)
with galvanic separation
084B7124
Necessary connections
Terminals:
25-26 Supply voltage 24 V a.c.
17-18 Signal from actuator (from NTC)
23-24 Supply to actuator (to PTC)
20-21 Pt 1000 sensor at evaporator outlet
1-2 Switch function for start/stop of regulation. If a switch is
not connected, terminals 1 and 2 must be shortcircuited.
Application dependent connections
Terminal:
12-13 Alarm relay
There is connection between 12 and 13 in alarm situa tions
and when the controller is dead
8-10 Relay switch for start/stop of fan
9-10 Relay switch for start/stop of solenoid valves
18-19 Current signal from other regulation (Ext.Ref.)
21-22 Pt 1000 sensor for monitoring
2-5 Current output for Sair/Saux temperature or ICAD actuator
for ICM valve
3-4 Data communication
Mount only, if a data communication module has been
mounted.
It is important that the installation of the data communi-
cation cable be done correctly. Cf. separate literature No.
RC8AC..
Connections
Supply voltage
24 V a.c. +/-15% 50/60 Hz, 80 VA
(the supply voltage is galvanically separated
from the input and output signals)
Power consumption
Controller
Actuator
5 VA
75 VA
Input signal
Current signal 4-20 mA or 0-20 mA
Digital input from external contact function
Sensor input 2 pcs. Pt 1000 ohm
Output signal Current signal
4-20 mA or 0-20 mA
Max. load: 200 ohm
Relay output 2 pcs. SPST
AC-1: 4 A (ohmic)
AC-15: 3 A (inductive)
Alarm relay 1 pcs. SPST
Actuator
Input
Temperature signal from
sensor in the actuator
Output
Pulsating 24 V a.c. to
actuator
Data communication
Possible to connect a data communication
module
Ambient
temperature
During operation
During transport
-10 - 55°C
-40 - 70°C
Enclosure IP 20
Weight 300 g
Mounting DIN rail
Display LED, 3 digits
Terminals max. 2.5 mm
2
multicore
Approvals
EU Low Voltage Directive and EMC demands re
CE-marking complied with.
LVD-tested acc. to EN 60730-1 and EN 60730-
2-9
EMC-tested acc. to EN50081-1 and EN 50082-2
Temperature sensor Pt 1000 ohm: ..........Kindly refer to catalogue RK0YG...
Valves: .............................................................DKRCI.PD.HT0.A
Data communication
Wire length: See appendix 2
CVQ/
CVMQ/
KVQ

Other manuals for Danfoss EKC 361

Related product manuals