Danfoss RET B + RF - Commissioning (RF only)

8
Commissioning (RF only)
Step 1 RET B-RF
Remove dial, press & hold
LEARN button for 3 seconds
(located under setting dial).
Do not replace the setting dial yet
NOTE: Thermostat now transmits
signal continuously for 5 mins
Step 2 RX1
Press and hold buttons PROG and CH1 until
green light fl ashes.
Step 3 RX2/RX3
For RX2 or RX3 repeat steps 1 and 2 for each
thermostat and channel, leaving at least 5 mins
between the commissioning of each thermostat.
Step 4 RET B-RF
Replace thermostat setting dial.
LEARN
GB - Installation Instructions