Need help?Do you have a question about the Danfoss RET2000 and is the answer not in the manual?
General| Type | Electronic Room Thermostat |
|---|---|
| Protection Class | IP30 |
| Protection Rating | IP30 |
| Temperature Range | 5°C to 30°C |
| Power Supply | 230V AC |
| Setpoint Range | 5°C to 30°C |
| Accuracy | ±0.5°C |
| Mounting | Wall mounting |
| Output | Relay |
Shows when heating output is active in heating mode only.
Indicates the unit is manually set to standby mode.
Shows when cooling output is active in cooling mode only.
Flashes to indicate low battery levels in battery-powered units.
Signifies that the keyboard lock has been enabled during installation.
To Next Page
