VLT
®
5000 Series
Programming
Description of choice:
The required text can be written via serial
communication or by means of the arrow
keypads on the LCP.
554 Display text 2
(DISPLAY TEXT ARRAY 2)
Value:
Max. 8 characters
[XXXXXXXX]
Function:
Here, a text of max. 8 characters can be written that will
be shown in display line 2, provided LCP Display Text
[29] has been selected in parameter 009 Display line 2
Description of choice:
The required text can be written via serial
communication or by means of the arrow
keypads on the LCP.
580–582 Defined parameters
(DEFINED PARAM.)
Value:
R
ead only
Function:
The three parameters contain a list of all parameters
defined in the VLT. Each parameter contains up to
116 elements (parameter numbers). The number of
parameters that are in use (580, 581, 582) depends
on the respective VLT configuration. When a 0 is
used as a parameter number, the list ends.
Description of choice:
✭ = factory setting. () = display text [] = value for use in communication via serial communication port
MG.51.A9.02 - VLT is a registered Danfoss trademark
157
To Next Page
Loading...
