Danfoss VLT 5000 Series - Manual

1
MG.10.J4.02 – VLT is a registered Danfoss trade mark
VLT
®
5000 SyncPos option
Contents
Chapter 1
■■
■■
■ Safety ..................................................................... 3
Chapter 2
■■
■■
■ Introduction .......................................................... 5
Chapter 3
■■
■■
■ Input/Output terminals........................................ 9
Chapter 4
■■
■■
■ Fundamentals of the SyncPos program .......... 19
Starting the SyncPos option step-by-step ............ 25
Optimizing the PID-Controller ............................... 31
Chapter 5
■■
■■
■ PC Software interface ......................................... 3 2
Chapter 6
■■
■■
■ Programming with SyncPos .............................. 5 9
Introduction and basics ......................................... 61
■■
■■
■ Software Reference ............................................ 6 8
List of Commands ................................................. 68
All commands from ACC to #INCLUDE ............... 70
■■
■■
■ Parameter Reference ........................................ 125
VLT and SyncPos parameter ............................... 125
VLT parameters .................................................... 126
SyncPos parameters ............................................ 129
Chapter 7
■■
■■
■ Messages and Error Reference ....................... 155
Chapter 8
■■
■■
■ Program Samples ............................................. 163
Chapter 9
■■
■■
■ Appendix ............................................................ 167
Glossary terms ..................................................... 168
What's new in PC Software 2.0x /
Option Card Software 3.00? ................................ 168
What's new in PC Software 2.1x /
Option Card Software 3.1x? ................................. 169
Index .................................................................... 179