Danfoss VLT 5000 Series - Warnings and alarms; Auto-optimisation OK; Auto-optimisation not OK; ALARM: 16

163
MG.10.J4.02 – VLT is a registered Danfoss trade mark
VLT
®
5000 SyncPos option
■ Error in global parameter ...
SyncPos
Error in global parameter part of file.
Meaning
When re-saving a configuration ("CONTROLLER"
→→
→→
→ "PARAMETERS"
→→
→→
→ "RESTORE FROM FILE") the
computer recognizes that the data in the area of the global parameters is formatted incorrectly.
Causes
In order to be able to save a file, the following conditions must be fulfilled:
• Identical software versions, that provides same number and order of the parameters
• same configuration (e.g. same number of axes)
■ Lost connection to ...
SyncPos
Lost connection to #%d!
Meaning
If the VLT is turned off or the plug is pulled, etc. the window is disconnected from the VLT and the lost
connection is registered.
■■
■■
■ Timeout: no reply from VLT
SyncPos
Timeout: no reply from VLT
Meaning
The VLT does not answer; check the connection.
Program samples