Danfoss VLT 5000 Series Manual

VLT
®
5000 SyncPos option
MG.10.J4.02 – VLT is a registered Danfoss trade mark
38
Following chapter describes the individual menus of the SyncPos user interface. If
you are familiar with the Windows interface then, naturally, you can skip the
familiar menus and immediately move to the SyncPos-specific information.
The basic information about program layout, command structure, interrupt,
elements of the programming language, arithmetic and User Unit can be found in
the introduction to the software reference. All commands and parameters are
described in detail and then alphabetically ordered in the chapters Software
Reference and Parameter Reference.
PC Software Interface

Danfoss VLT 5000 Series Specifications

General

Frequency	50/60 Hz
Cooling Method	Forced Air Cooling
Enclosure	IP20
Protection Features	Overcurrent, Overvoltage, Undervoltage, Overtemperature, Short Circuit
Communication Interfaces	RS-485, Profibus
Enclosure Rating	IP20