Danfoss VLT 5000 Series Manual

VLT
®
5000 SyncPos option
MG.10.J4.02 – VLT is a registered Danfoss trade mark
60
The following chapters describe how to program using SyncPos. Beginners
should read the basic explanations on the programming language SyncPos, i.e.
program layout, command structure, interrupt, elements of the programming
language, arithmetic and user unit. Experienced users should inform themselves
about the SyncPos-specific basic principles, e.g. user unit or parameters.
All commands are described in the Software Reference, first in a general
overview and then alphabetically ordered, in detail and complemented with short
examples. You can reconstruct as many as 50 programs with assistance of the
information in the example programs in this chapter.
And in chapter Parameter Reference all the parameters are described, first in
general and then in detail.
Programming with SyncPos

Danfoss VLT 5000 Series Specifications

General

Frequency	50/60 Hz
Cooling Method	Forced Air Cooling
Enclosure	IP20
Protection Features	Overcurrent, Overvoltage, Undervoltage, Overtemperature, Short Circuit
Communication Interfaces	RS-485, Profibus
Enclosure Rating	IP20