Danfoss VLT 5000 Series Installation Startup Check List

8
Pre-Installation Check
• Record motor data information
– Motor Power
– Motor Voltage
– Motor Frequency
– Motor Current (FLA)
– Motor Speed (RPM)
Write down the motor nameplate information. This will be important later during
programming. A conversion between HP and kW must be calculated 1Hp = 0.75kW.
In the example 20Hp = 15kW.
Motor Power = ___________________ kW
Motor Voltage = __________________ Vac
Motor Frequency = 50Hz 60Hz
Motor Current = __________________ Amps
Motor Speed = ___________________RPM

Danfoss VLT 5000 Series Specifications

General

Frequency	50/60 Hz
Cooling Method	Forced Air Cooling
Enclosure	IP20
Protection Features	Overcurrent, Overvoltage, Undervoltage, Overtemperature, Short Circuit
Communication Interfaces	RS-485, Profibus
Enclosure Rating	IP20