VLT
®
FCM Series
All about FCM
300
Functions to programme, to control, and to monitor via bus (PROFIBUS) or by PC.
Parame-
ter No. Function Range/number of settings/value Factory setting
Data
type
Conv.
index
600 Operating data: Operating hours 0 - 130,000.0 hours 5 0
601 Operating data: Hours run 0 - 130,000.0 hours 7 73
603 Operating data: Number of power-up’s 0 - 9999 7 73
604 Operating data: Number of overtemp. 0 - 9999 6 0
605 Operating data: Number of overvoltages 0 - 9999 6 0
615 Fault log, read-out: Error code Index XX - XXX 6 0
616 Fault log, read-out: Time Index XX - XXX 5 0
617 Fault log, read-out: Value Index XX - XXX 7 -1
619 Reset of hours-run counter No reset/reset No reset 3 0
620 Operation mode 3 Normal function 5 0
621 Nameplate: FC motor type Depends on unit 5 0
624 Nameplate: Software version no. Depends on unit 9 0
625 LCP version Depends on unit 9 0
626 Nameplate: Database identification no. Depends on unit 9 0
628 Nameplate: Application option type 9 -2
630 Nameplate: Communication option type 9 0
632 BMC software identification 90
633 Motor database identification 90
634 Unit identification for communication 9 0
635 Software part No. 90
Conversion index:
This number refers to a conversion figure to be used
when writing or reading via serial communicati
on
with a frequency converter.
See Databytes in Serial Bus.
D
ata type:
Data type shows the type and length of the telegram.
Data type Description
3 Integer 16
4 Integer 32
5Unsigned8
6Unsigned16
7Unsigned32
9Textstring
MG.03.H3.02 - VLT is a registered Danfoss trademark
103
To Next Page
Loading...
Need help?
General