How to fix an air leak from the barrel area of my Dangerous Power paintball equipment?
If you're experiencing an air leak from the barrel area of your Dangerous Power paintball equipment: * **Valve pin at incorrect position:** Remove the LPR and grease the spring and valve pin. * **Worn valve pin:** Replace the valve pin.
What to do if my Dangerous Power Fusion paintball equipment won't fire?
If your Dangerous Power Fusion won't fire, there are several potential causes: * **Low battery power:** Replace the battery. * **Low air pressure:** Refill the air system. * **Solenoid out of place:** Open the grip and gently press the solenoid forward. * **LPR pressure too low:** Adjust the LPR pressure without a paintball present.
Why won't my Dangerous Power Fusion paintball equipment turn on?
If your Dangerous Power Fusion paintball equipment isn't turning on, consider these possibilities: * **Not activated:** Hold down the operating button for more than 4 seconds to activate. * **Low battery power:** Replace the battery. * **Incorrect battery connection:** Check the battery cable connection to the PC board terminal to ensure it is correct.
What to do if my Dangerous Power Fusion paintball equipment doesn't cycle completely?
If your Dangerous Power Fusion isn't cycling completely, here are a few things to check: * **Air pressure too low:** Adjust the operating pressure to between 250 and 300 psi. * **Low battery power:** Replace the battery. * **Worn striker o-ring:** Replace the o-ring on the striker.
What causes my Dangerous Power paintball equipment to chop paintballs internally?
Internal paintball chopping in your Dangerous Power paintball equipment can be due to: * **Worn ball detent:** It is recommended to call the authorized dealers for replacement. * **Sensor system off:** Ensure the sensor system is switched to the 'ON' position. * **Low battery power:** Try changing the battery.
What to do if my Dangerous Power Fusion paintball equipment won't fire with the sensor system on?
If your Dangerous Power Fusion won't fire with the sensor system activated: * **No paintball present:** Make sure to turn on the loader. * **Sensor system is unclean:** See“Sensor System Maintenance”. * **Ball detent is damaged:** Call the authorized dealers for replacement. * **Paintball broke inside:** See“Bolt and Sensor System Maintenance”.
Why is my Dangerous Power paintball equipment breaking paintballs when shooting out of the barrel?
If your Dangerous Power paintball equipment is breaking paintballs when shooting, it could be because the barrel size doesn't match the paintball size. The stock barrel size is 0.693; change it if necessary.
What to do if the pressure gauge on my Dangerous Power paintball equipment will not move?
If the pressure gauge on your Dangerous Power paintball equipment isn't moving, it might be because the pressure used was too high. Replace the gauge.
Emphasizes safety precautions, proper use, and age recommendations for the marker.
Details the procedure for adjusting the Operating Pressure Regulator (OPR).
Details the procedure for adjusting the Low Pressure Regulator (LPR).
Details how to clean and maintain the sensor system for optimal performance.
Lists common problems, their possible causes, and solutions.
General| Marker Type | Electronic |
|---|---|
| Barrel Thread | Autococker |
| Feedneck | Clamping |
| Eyes | Yes |
| Type | Spool Valve |
| Barrel Length | 14 inches |
| Battery | 9V |
| ASA | On/Off |
| Firing Modes | Semi-Auto, PSP, NXL |
To Next Page
