DANGO CR-01 - Crown Position Functions

CR-01
POSITION 1: WATCH IS RUNNING
PUSHED ALL THE WAY IN, WATCH IS RUNNING, DATE IS
ACTIVE. ROTATING THE CROWN IN THIS POSITION
YIELDS NO RESULTS.
POSITION 2: SETTING THE DATE
- PULL THE CROWN OUT TO POSITION 2.
(WATCH IS STILL RUNNING)
- ROTATE THE CROWN COUNTER CLOCKWISE UNTIL
THE REQUIRED DATE APPEARS.
- PUSH THE CROWN BACK INTO POSITION 1 TO SET
THE REQUIRED DATE.
POSITION 3A: SETTING THE TIME
- PULL THE CROWN OUT TO POSITION 3.
(WATCH IS STOPPED)
- ROTATE THE CROWN FORWARD & BACKWARD
UNTIL THE DESIRED TIME IS DISPLAYED
- PUSH THE CROWN BACK INTO POSITION 1 TO SET
THE DESIRED TIME.
STOP WATCH
- PRESS PUSH-BUTTON A ONCE TO START YOUR TIMER.
PRESS PUSH-BUTTON A AGAIN TO STOP.
- PRESS PUSH-BUTTON B TO RESET THE STOP WATCH
POSITION 3B: SETTING CHRONOGRAPH HANDS
& SUB-DIALS
- PULL CROWN OUT TO POSITION 3
- KEEP PUSH BUTTONS A & B DEPRESSED
SIMULTANEOUSLY FOR AT LEAST 2 SECONDS UNTIL
CHRONOGRAPH HAND MAKES A FULL ROTATION.
THIS PUTS YOU IN SETTING MODE.
- BY PRESSING PUSH BUTTON A, YOU CAN NOW
SET YOUR CHRONOGRAPH HAND POSITION.
- BY PRESSING PUSH BUTTON B YOU CAN CHOOSE
BETWEEN SUB-DIALS AND BACK TO CHRONOGRAPH HAND.
- BY PRESSING AND HOLDING DOWN PUSH-BUTTON A,
YOU CAN RAPIDLY ROTATE THE SUB-DIAL HANDS.
- PUSH THE CROWN BACK INTO POSITION 1 TO
CONTINUE RUNNING TIME.