Dash DSIM100 - Setting Up Your Shaved Ice Maker; Initial Setup Steps

∙ 10 ∙
SETTING UP YOUR DASh shaved ice maker
Place the Base on a stable and dry surface.
Install the Motor Unit on the Base.
Align and insert the Exterior Bowl onto the assembled Motor
Unit and Base. The two notches on the side of the Exterior Bowl
should fit into the two notches on the inside of the Motor Unit.
Lastly, plug in the Power Cord.
1
2
3
NOTE:
Please clean your Dash Shaved Ice Maker before rst using. Refer to pages 10-14 for instructions
and details.